Tuesday, February 25, 2014

1997 toyota camry timing belt replace

1997 Toyota camry timing belt replace?


My Toyota had an oil pooring out of the engine. The oil pump housing was leaking so I pulled it apart without setting any timing marks. Know it is time to put it togeather and I have set the everything to the right marks again. How many marks do I have to line up? Is it just the cam and the crank timing mark? George what engine? TDC is starting point whichever way you try to turn around this. As uk asks, depends on the engine; the 4 banger is the easier of the available engines. Only two marks to line up, crank and cam. Crank lines up to tdc marker on timing belt cover, cam lines up (if I remember right) through a small alignment hole in the cam gear to a raised mark on the head. Word of advice while you're in there - change the water pump.








Related Posts:




  • 2004 kia optima changing timing belt what else

    2004 Kia Optima changing timing belt - what else?I have a 2004, KIA Optima, with 68k miles, 4 cylinder LX automatic with AC. I read the sticky. Followed the link to Home - National Automotive Serv...


  • 93 lexus gs300 timing belt question

    93 lexus gs300 timing belt questioni just got a 93 gs300 have no records of when the belt was changed so i'm planning on changing it but i was told to only bring it back to lexus to have the belt...


  • 1990 honda accord timing belt

    1990 Honda Accord Timing BeltI need to replace the timing belt on my mothers Accord. Anybody know how difficult that would be? It doesn't look like there's a lot of room to work in there. Will the...


  • 2003 honda civic ex stumbles

    2003 Honda Civic EX stumblesJust had a timing belt replaced on this car. It has 142k miles on it. Before and after timing belt was done it would feel like the car would stumble or was about shut o...


  • Cub cadet 1050 changing xmsn drive belt

    Cub Cadet 1050 Changing Xmsn Drive BeltI have to change the xmsn drive belt on a cub cadet LT1050. I have been told by some folks that you have to unbolt the engine and then lift it to get the bel...